Fujifilm X-PRO2: Electronic Range Finder

category: Cameras • 1 min read

How to set the Electronic Range Finder on the Fujifilm X-PRO2?

  1. Switch from any AF mode to the single point mode.
  2. Push the viewfinder selector lever (at the front of the camera) to the left (as when you are looking through the viewfinder) to the Digital viewfinder and the X-PRO2 will display the Electronic Range Finder in the bottom right of the viewfinder.
  3. You can change the magnification of the section of the image in the ERF by repeatedly pushing the rear control wheel.

Note 1

If the camera is in a multiple point AF, like Face Detection, Zone-AF, Wide-AF… Then it’s very likely that the focus will be done on multiple AF points. So which one to display in the Electronic Range Finder?

So Fujifilm decided to not enable the Electronic Range Finder with these modes

Note 2

Enabling the Electronic Range Finder significantly slows down the AF (currently with firmware 2.0.1